Login  Register

Re: PROJECT: home molding meltas and shotguns

Posted by General Biakal on Sep 12, 2011; 12:40pm
URL: http://the-lost-and-the-damned.71.s1.nabble.com/PROJECT-home-molding-meltas-and-shotguns-updated-tp6782963p6783279.html

its actually really simple...

first you build a press as small as possible. 4x3 in lego is ideal. use flat lego tiles to line the press and the bottom of the press.

get a bowl with ALMOST boiling water in.

cut your Instant mold stick in half

drop both bits into hot water

wait a few seconds, then take ONE half out and place in the bottom of the press

spread it with your fingers and then push the top press hard into it to level it off

remove press and before it cools push your original into the gel so it is half buried.

leave to cool. (40 seconds ish- blow on it) but DO NOT TAKE OUT OF PRESS

when cool fish the second half out the water and place on top of the originals and push it with your thumb

get the press peg and push it like fuck either by hand or in a vice

go have a wank or a cuppa

when cooled remove (to avoid stressing the mould take the lego to bits round it)

pop it in half and remove the original

fill both sides of the mould with GS in little bits, making sure all the detail is filled

fill both sides to "just over"

put bottom in press, then put top in

put press pegin and push like fuck

leave for several hours

takeit to bits, trim flash. viola!
 
"WAAAAGH! VROOM VROOM!!! DAKKA DAKKA DAKKA! Dead gud innit yoof?!" - typical Mekboy sales pitch