Re: Citadel £ine Ca$t - what you really need to know!

Posted by Marchomer on Jun 04, 2011; 1:35pm
URL: http://the-lost-and-the-damned.71.s1.nabble.com/Citadel-ine-Ca-t-what-you-really-need-to-know-tp6396431p6439180.html

I heard that apparently the problem of the missing parts and the bubbles is due to the low density of the resin and the strong pressure which the material is put into the molds...
Once again, congratulations to GW not only for the poor quality of the material, the overcharge and the uselessness of this resin, but also for the incompetence.

Obviously there are only three possibilities:
0.The machines have not been tested enough;
1.The GW doesn't care about the final result of the miniatures;
10.Both hypotheses;

General Biakal wrote

see, funny story on this... i was at the lenton store on saturday for the launch, and all the staff were dressed in costume. and the VERY cute girl who works at the store was dressed as an wood elf waywatcher. i asked her out and she said she would have a drink with me in bugmans after the store closed.

she never turned up.

so FUCK finecast and FUCK GW.

 Good point!